Download Print this page

Removing The Appliance; Transportation; Protection Against Frost (Emptying The Appliance) - Siemens SX SERIES Operating Instructions Manual

Hide thumbs


Table of Contents
Installation and connection

Removing the appliance

Also observe
the sequence of worksteps here.
1. Disconnect the appliance from
the power supply.
2. Turn off the water supply.
3. Undo the waste water and drinking
water connection.
4. Loosen fastening screws for
the furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.


Empty the dishwasher and secure loose
Drain the appliance according to the
following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF switch (.
4. Select programme with the highest
The expected programme duration is
indicated on the numerical display
5. Press START button `.
6. Close the door.
Programme sequence starts.
7. Open door after approx. 4 minutes.
8. Press START button ` until :
is indicated on the digital display.
9. Close the door.
10. Open door after approx. 1 minute.
The numerical display indicates
11. Switch off ON/OFF switch (.
12. Turn off the tap, disconnect supply
hose and drain water.
Transport appliance upright only.
(This prevents residual water from
running into the machine control and
damaging the programme sequence.)
Protection against frost
If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e )

Hide quick links:


Table of Contents

  Also See for Siemens SX SERIES

This manual is also suitable for:

Sn seriesSx series