Download Print this page

Water Hardness Table; Using Special Salt; Detergents With Salt Component - Siemens SX SERIES Operating Instructions Manual

Hide thumbs

Advertisement

To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of :
reached, the display jumps back
to :
(off).
2. Press START button `.
The chosen setting has now been
stored.
3. Close the door.

Water hardness table

Water softening system/Special salt
has been

Using special salt

Always refill with special salt
immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode the
rinsing tank.
1. Open the screw-type cap of the
compartment 1b.
2. Fill the tank with water (only required
when switching on the appliance for
the first time).
3. Then add dishwasher salt (not table
salt or tablets).
The water is displaced and runs out.
As soon as the salt refill indicator @
on the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
component
D e t e r g e n t s w i t h s a l t c o m p o n e n t
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
special salt must be used.
en
11

Hide quick links:

Advertisement

loading

  Also See for Siemens SX SERIES

This manual is also suitable for:

Sn seriesSx series