Siemens TE509 Series Instruction Manual page 42

en de
Calc'n'Clean
Duration: approx� 35 minutes�
Calc'n'Clean combines the separate func-
tions of descaling and cleaning� If both
programmes are due to be run soon, the
espresso machine automatically suggests
this service programme�
Important: If there is a filter in the water
tank (17), it needs to be removed before the
service programme is run�
If the message
Calc'n'Clean required!
appears on the display, press the
button (13) for 3 seconds and then
press the start button (10)� The service
programme will start�
To run Calc'n'Clean before being prompted,
e
j
press the off /
least 3 seconds� Then press the
j
button (13) briefly twice. Turn the upper
rotary knob (15) until
appears in the display� To start
Calc'n'Clean, press the start button (10)�
The display will guide you through the
programme�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Calc'n'Clean in progress
The appliance rinses twice�
Open drawer
● Open the drawer (4)�
Fill cleaner
● Drop a Siemens cleaning tablet in the
drawer (4) and close�
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the start button (10) again�
Remove the filter now if you have not
already done so�
Press the start button (10)�
38
e
off /
button (13) for at
e
off /
Start Calc'n'Clean
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (17) up to the 0.5 l mark and
then dissolve 1 Siemens descaling tablet
TZ80002 in it� When using TZ60002,
2 tablets must be dissolved�
● Press the start button (10)�
Place container
Press start
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6a)�
● Press the start button (10)�
j
Calc'n'Clean in progress
The descaling pro gramme will now run for
about 22 minutes�
Clean / Fill water tank
Press start
● Rinse the water tank (17) and refill it with
fresh water up to the max mark�
● Press the start button (10)�
Calc'n'Clean in progress
The descaling pro gramme now runs for
about 10 minutes and rinses the appliance�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again�
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue� Such residue can
cause corrosion� New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use�