Change Filter; Menu Settings - Siemens TE509 Series Instruction Manual

de en
The filter is no longer effective when the
display appears, or at

Change filter!

the latest after 2 months� It needs to be
replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance). Replacement
filters can be obtained from retailers or from
customer service (see "Accessories")� If no
new filter is used, turn the
�
No / Old
Note: You can use the filter indicator to
mark the month in which you inserted the
filter. You can also mark the month in which
you will need to replace the filter next (at
the latest after two months)�
Note: If the appliance has not been used
for a prolonged period (e�g� vacation) the
filter should be rinsed before the appliance
is used again� To do so, dispense a cup of
hot water and pour it away�

Menu settings

You can adapt the appliance to your indi-
vidual needs in the menu settings�
e
off /
1� Hold the
at least 3 seconds�
e
2� Press the off /
edly until the required menu item
appears in the display�
3� Select the required setting with the
upper rotary knob (15)�
4� Confirm by pressing the start
button (10)�
To leave the menu without making any
changes, turn the rotary selector to
press the start button (10)�
30
setting to
filter
j
button (13) down for
j
button (13) repeat-
Exit
You can set the following:
: Here you can set the time
Shut off
span after which the appliance automati-
cally switches off following the last drink
preparation� A time between 15 minutes and
4 hours can be set� The default time can be
shortened to save energy� To save power
you can specify a shorter period�
: Here you can set whether a water
Filter
filter is being used. If a water filter is not
being used, turn the setting to
a water filter is being used, turn the setting
to
Activate filter
to be rinsed before use (see "Water filter").
Start Calc'n'Clean
programmes (
) can be selected manually
cleaning
here� Press the start button (10) and run
the selected programme (see "Service
Programmes")�
Temp. : The brewing temperature (
middle / low
: The display language can be
Language
set here�
Water hardness
setting can be adjusted on this appliance�
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run� The factory setting for the
water hardness is 4�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier�
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute�
and
No / Old
. New water filters have
: The service
/
Calc'n'Clean descaling
) can be set here�
: The water hardness
� If
/
high /