Basic Setting2 Page - JVC VN-H157WPU Instructions Manual

Basic Setting2 Page

This page sets fundamental camera and encoding parameters.
This page is displayed by pressing the [Details] button in the Built-in Viewer.
Select the ④ [Set in "SD Card Record" Page] and click [OK] to move to the SD card recording settings page
( Page 8).
This page can be used during access using "admin" or "operator".
Click [Basic Setting2].
Memo:
If you enter the following URL directly into the address bar of Internet Explorer, you can open the [Basic
Setting2] page without going through the Built-in Viewer.
http://192.168.0.2/cgi-bin/display.cgi?basicmenu2.html
When the camera IP address has been changed from the default settings, replace 192.168.0.2 with the
changed IP address.
Press the [OK] button to enable the new settings.
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry
will be denied. Press the [Cancel] button to restore the invalid entry to the value before the change was
made.
"H.264 High" indicates the H.264 High Profile standard.
6
①
②
③
④