Electrical Connection; Permanent Connection - Electrolux 96699IH User Manual

INSTALLATION UNDER A
COUNTER
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
600 mm
600 mm
> 850 mm
THE LOAD DOOR REVERSAL
The load door can be installed by the
user in the opposite side. It can help to
easily put and remove the laundry or if
there is a limit to install the appliance.
(see separate leaflet).

ELECTRICAL CONNECTION

• Connect the appliance to a groun-
ded socket. Refer to the applicable
electrical requirements.
• Make sure that the electrical data on
the rating plate agrees with the pow-
er supply.
• Always use a correctly installed
shockproof socket.
• Do not use multiple plugs and exten-
sion cables. There is a risk of fire.
• All replacements of power supply ca-
ble must be carried out by our Serv-
ice.
• Make sure not to squash or cause
damage to the mains plug and cable
behind the appliance.
• Do not pull the mains cable to dis-
connect the appliance. Always pull
the mains plug.
• The plug must be dry.
The data about mains voltage, type of
current and the necessary fuse are on
the rating plate and in the "TECHNI-
CAL INFORMATION" chapter. The rat-
ing plate is behind the load door (see
the "PRODUCT DESCRIPTION" chap-
ter).
The appliance has a power supply ca-
ble with plug fitted with 13 A fuse. If
necessary, replace the fuse in the plug
by 13 A ASTA BS 1363/A approved
fuse.
The wires in the power supply cable are
coloured as follow:
A) green and yellow - ground — earth
(E)
B) brown - live (L)
C) cord clamp
D) blue - neutral (N)
The green and yellow coloured wire
must be connected to the terminal with
E mark or the ground
green and yellow coloured terminal.
The blue coloured wire must be con-
nected to the terminal N or black col-
oured .
The brown coloured wire must be con-
nected to the terminal L or red col-
oured .
The wires of the cable must be no cut
or stray strands of wire present and the
cable clamp must be secure over the
outer sheath.

Permanent connection

The necessary condition of permanent
connection is to install a double-pole
isolating switch directly on the supply
terminals.
The type of switch must be correct for
the necessary load and must align with
applicable electrical requirements.
The switch must not break the yellow
and green coloured ground wire.
ENGLISH
33
A
B
C
D
mark or the