Panasonic KX-PS8000 Setup Manual page 66

Error Message
Imaging Unit wearing out
Transfer wearing out
Fuser Unit and Oil Roll
Worn out
Fuser Unit wearing out
Oil Roll
Worn out
Oil Roll wearing out
Black Toner
Empty
Cyan Toner
Empty
Magenta Toner
Empty
Yellow Toner
Empty
Low Black Toner
Low Cyan Toner
Low Magenta Toner
Low Yellow Toner
Memory Overflow
Too hot to print Label
Remove Label, Cancel job
66
Possible Cause
Imaging unit is wearing out.
Second transfer roller is wearing
out.
Fuser is worn out.
Fuser is wearing out.
Oil supply roll is worn out.
Oil supply roll is wearing out.
Black toner cartridge is empty.
Cyan toner cartridge is empty.
Magenta toner cartridge is empty.
Yellow toner cartridge is empty.
Black toner cartridge is almost
empty.
Cyan toner cartridge is almost
empty.
Magenta toner cartridge is almost
empty.
Yellow toner cartridge is almost
empty.
There is not enough memory in the
printer.
The printer is too hot or room
temperature is too high to print
Labels.
Corrective Action
Replace the imaging unit soon.
Replace the transfer roller soon.
Replace the fuser unit now.
Replace the fuser unit soon.
Replace the oil supply roll now.
Replace the oil supply roll soon.
Replace the black toner cartridge
now.
Replace the cyan toner cartridge
now.
Replace the magenta toner
cartridge now.
Replace the yellow toner
cartridge now.
Replace the black toner cartridge
soon.
Replace the cyan toner cartridge
soon.
Replace the magenta toner
cartridge soon.
Replace the yellow toner
cartridge soon.
Press CONTINUE button on the
panel or wait for auto recovery
after 10 seconds. (only when
Auto Continue setting is ON)
Perform the following procedure.
1. Add memory.
2. Select a lower resolution on the
Printer Driver.
3. Select Dither A on the Printer
Driver.
Wait until the printer cools down,
or use in a cooler place [below
32.5°C (90.5°F)].