Setting The Handset Pin; Registering A Handset To A Base Unit - Panasonic KX-TCD705BX Operating Instructions Manual

KX-TCD705BX 12/7/01

Setting the Handset PIN

You can program a 4 digit password for the handset. The factory pre-set is 0000.
Changing the password may prevent the unauthorised use of your unit by another person.
In the 'Setting Handset' mode
Y or V
S/U
Select
'Other
Option'
NOTE: Once you have programmed the password, you
cannot confirm it. We recommend you write down the
password. If you forget it, please consult your nearest
Panasonic Service Centre.

Registering a Handset to a Base Unit

The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out before
initial use.
Z and hold (Ï) on base unit for more than 10 seconds. A series of beeps
begin to sound.
In the 'Setting Handset' mode
Y or V
S/U
Select
'Registration'
Enter Base PIN
NOTES:
• Charge the optional handset batteries for about 10 hours before initial use.
• Register the handset number within 1 minute. If not registered within 1 minute,
ZP on the handset to cancel the programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only via the displayed base
unit (even if the radio areas overlap with neighbouring base units).
2:28 pm Page 41
Y or V
S/U
Select
'Change
Hset PIN'
Y or V
S/U
Select
'Register
H/set'
Please Wait...
or V
Y
• If registration is successful, a confirmation tone
sounds and display returns to the standby mode.
The selected base number is displayed in the
standby mode.
• If registration is not successful within 5 minutes, an
error tone sounds and display returns to original
standby mode.
Enter Old PIN
Enter the current
4-digit handset
PIN.
Y or V
S/U
Select Base
No. to register
handset (1-4).
41
Enter New PIN
Enter the new 4-digit
PIN TWICE.
If 2nd PIN entry is
incorrect, an error
tone sounds and
display returns to
'Enter New PIN'. If
PIN is correct, a
confirmation tone
sounds.
Please Wait...
Handset searches
selected base.