The Setting Method Of Jig (Handset) - Panasonic KX-TGC450G Service Manual

11.4 The Setting Method of JIG (Handset)
This section explains the PC setting to use command required in
(Preparation)
• Serial JIG cable: PQZZ1CD300E*
• PC which runs in DOS mode
• Batch file CD-ROM for setting: Refer to parts list of
Note:
*: If you have the JIG Cable for TCD500 series (PQZZ1CD505E), change the following values of resistance. Then you can use it
as a JIG Cable for both TCD300 and TCD500 series. (It is an upper compatible JIG Cable.)
11.4.1 Connections
Connect the DC Power or Battery to BATT+ and BATT-.
Connect the JIG cable GND (black) to GND.
Connect the JIG cable UTX (yellow) to UTX and URX (red) to URX.
DC Power
1
or Battery
Note:
*: COM port names may vary depending on what your PC calls it.
B A T T +
[9.3.1 Check Point (Handset)]
[15.5.6 Fixtures and Tools]
URX (red)
3
3 UTX (yellow)
U T X
U R X
2 GND (black)
G N D
JIG Cable
B A T T -
- 60 -
To Serial Port
(com port 1*)
PC