Panasonic KX-TCD505E Operating Instructions Manual page 11

Battery Information
After your Panasonic battery is fully
charged:
Ni-MH Batteries (typical 700 mAh)
Operation
While in use (TALK)
While not in use
(Standby)
Ni-Cd Batteries (typical 250 mAh)
Operation
While in use (TALK)
While not in use
(Standby)
• Times indicated are for peak
performance.
• The battery operating time may be
shortened depending on usage
conditions and ambient temperature.
• Clean the charge contacts of the
handset and the base unit with a
soft, dry cloth once a month. Clean
more often if the unit is subject to
grease, dust or high humidity.
Otherwise the battery may not charge
properly.
• The batteries cannot be overcharged
unless they are repeatedly removed
and replaced.
• For maximum battery life, it is
recommended that the handset not be
recharged until the battery icon flashes
.
Helpline Tel.No. :U.K. 08700 100 076 R.O.I. 01289 8333
Operating Time
10 hrs approx.
120 hrs approx.
Operating Time
4 hrs approx.
40 hrs approx.
Replacing the
Batteries
If the icon flashes after a few
telephone calls even when the handset
batteries have been fully charged, both
batteries must be replaced.
• Charge new batteries for
approximately 7 hours before initial
use.
(The telephone line cord must not be
connected to the telephone socket
at this time.)
• When replacing the batteries, be
sure to set up the battery type even
if you install the same type of
batteries to initialise battery
remaining memory of your handset.
(See Setting the Battery Type on
page 53.)
• Do not use non-rechargeable batteries.
If non-rechargeable batteries are fitted
and start charging, it may cause the
leakage of the battery electrolyte.
• Press the notch on the cover firmly and
slide it as indicated by the arrow.
Replace both batteries (Page 10) and
close the cover then charge the
handset for about 7 hours.
Please order Panasonic
P03P (Ni-MH) or P03H (Ni-Cd)
batteries.
Setting up
11