Advertisement
TG7150FX_7170FX(e)_QG.fm Page 4 Thursday, August 24, 2006 10:48 AM
Feature
Handset ringer volume
Changing ringtone
(outside calls)
7 Frequently asked questions
Question
What kind of power outlet
should I connect the AC
adaptor to?
Why is w flashing?
Why can I not make calls?
Why is the handset display
blank?
What should I do when the
handset does not turn on?
How long should I charge new
batteries?
Operation
{j/OK} i "Handset Setup" i {>} i
"Ringer Setup" i {>} i "Ringer Volume"
i {>} i Press {^} or {V} to select the desired
volume. i {>} i {ih}
{j/OK} i "Handset Setup" i {>} i
"Ringer Setup" i {>} i "Ext. Ringtone"
i {>} i Select the desired ringtone. i {>} i
{ih}
Cause & solution
L Connect the AC adaptor to a 220–240 V outlet.
L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
L The handset is not registered to the base unit. Register it.
{j/OK} i "Handset Setup" i {>} i
"Registration" i {>} i "Register H.set" i
{>} i Press and hold {x} on the base unit for about 3
seconds, until the registration tone sounds. i Wait until
"Enter Base PIN" is displayed. i Enter the base unit
PIN (default: "0000"). i {j/OK}
L The dialling mode setting is incorrect. Set to "Tone" or
"Pulse" as needed.
L The handset is not turned on. To turn the power on, press
{ih} for about 1 second.
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
L Charge the batteries for about 7 hours.
–
–
4
Advertisement
