Table of Contents
Advertisement
For best results avoid printing on areas where the flap overlaps the
envelope. Printing where the envelope varies in thickness may be
uneven.
Printing on Continuous-Form Paper with the
CSF Installed
If you use single part continuous-form paper you can leave the
CSF installed on your printer and alternate between printing on
continuous-form paper or sheets from the CSF. Use the paper park
feature, described in the following pages, to select the form you
wish to print upon.
When paper is moved forwards to the print position from the park
position in the continuous-form mode, the FORM FEED button
must be used.
This method of alternating between forms is not recommended
when multipart continuous-form paper is used.
Setting the PARK/TOF
This establishes the position of the first print line on each page. The
red line on the ribbon shield shows the baseline of the current
position and helps you place the TOF where you want it.
If you are using a word processor that sets its own top margin, set
the TOF for the topmost line on the page. Otherwise we recommend
positioning the top of the page under the bail; the first line of
printing will then be about one inch from the top of the page.
Setup 1 – 27
Advertisement
Table of Contents
