D - Maintenance And Servicing; Specifications; Reminder For Customer - Panasonic MC-CG881C Operating Instructions Manual

D - MAINTENANCE AND SERVICING

CAUTIONS
• The plug must be removed from the socket outlet
before cleaning or maintaining the appliance.
• DO NOT use hot air or hot surface to dry filters.
Dry them at room temperature for approximately 24
hours.
• IMPORTANT: Before re-installing the washable
filters, make sure they are completely dry to avoid
damaging the appliance.
Indicator for replacing the paper dust bag.
Turn the power control to the highest setting and lift the nozzle
off the fl oor. If the dust indicator turns red, the paper dust bag
is full and requires replacing the paper dust bag.
NOTE: If the paper dust bag is not properly installed, the dust
cover will not close. Be sure to check that the paper
dust bag is properly installed before operating the
appliance, otherwise dust will leak out.
The paper dust bag can easily lay on the dust cover
packing or clip between the bag collar and the body,
so be sure to properly extend it into the body of the
appliance.
Replacing the paper dust bag
D-1 Hold the dust cover catch and raise the dust cover until
it clicks properly.
D-2 Remove the basket and throw away the paper dust bag.
D-3 Set the basket fi rst to the appliance and set a new paper
dust bag to the basket.
D-4 Close the dust cover properly until you hear it click.
Floor nozzle
D-5 Inspect once a month.
Using an old toothbrush or similar tool,clean any dirt or
lint from the brush.
Vacuum cleaner body
D-6 Wipe with a soft cloth soaked with water.
Maintaining the Pre-motor Filter
Follow the procedure written below when the suction power is
not restored after replacing a new paper dust bag.
D-7 Remove the pre-motor fi lter.
D-8 Wash gently with water and then allow to dry in a
shaded location.
D-9 Return the pre-motor fi lter to its original position.
NOTE: Make sure you remember to replace the fi lter.
If the fi lter is not installed, it will cause motor
failure.
• Do not wash the fi lter in a washing machine or dry it
with a dryer or other source of hot air.
Exhaust filter
D-10 Exhaust fi lter, is installed in the rear side of the
appliance. This fi lter retains any small dust particles
which may be present in the expelled air. It is advisable
to change the fi lter once or twice a year, depending on
use. To change the fi lter, hold the exhaust cover (as
illustrated) and pull it out. After changed the fi lter, set the
exhaust cover to its position (as illustrated).
IMPORTANT: Never use the cleaner without the correct fi lters
properly installed. Failure to do so may result in
damage to the motor.
What to do if your cleaner does not work
Check that the appliance is correctly plugged in and that the
socket outlet is working. If the thermal cut-out device has
operated, wait until it resets automatically after approximately 60
minutes.
If after having checked the above mentioned points, the
appliance does not work, take it to an Authorized Service Centre
to be repaired.
What to do when the suction performance reduces
• Stop the appliance and unplug from the socket outlet.
• Check whether the wands, hose and accessories are blocked or
not. If they are blocked, remove the obstruction.
• Check whether the paper dust bag is full. If it is full, replace it.
• Check whether the pre-motor filter or exhaust filter is blocked
with dust.
If they are blocked, clean them out or replace them.

SPECIFICATIONS

Power source
Max. Input
Nominal input
Dimensions
(W x L x H)
Net weight
Extension wands
Dusting brush
Crevice nozzle
Upholstery nozzle
Optional Accessory
Product name
Paper dust bag (PACK 4/u.)

REMINDER FOR CUSTOMER

The model and serial number of this product may be found on the
nameplate located at the underside of your cleaner. You should
note the model and serial number in the spaces provided and
retain this book as a permanent record of your purchase.
Model Number. .............................................................................
Serial No. ......................................................................................
Date Purchased. ...........................................................................
Where Purchased. ........................................................................
25
MC-CG881C
230 V~50 Hz
1600 W
1300 W
312 mm x 489 mm x 243 mm
6.5 kg
Telescopic
√
√
√
Model number
C-17H