Cisco Nexus 2000 Series Installation Manual page 99

Chapter 3 Using a Fabric Extender with a Cisco Nexus 9000 Series Switch
Table 3-2 Supported Transceivers and Connector for the Cisco Nexus 2248TP-E FEX Interfaces
Transceiver or Connector
QSFP-4X10G-AOC5M
QSFP-4X10G-AOC7M
QSFP-4X10G-AOC10M
QSFP-4SFP10G-CU1M
QSFP-4SFP10G-CU3M
QSFP-4SFP10G-CU5M
QSFP-4SFP10G-CU7M
QSFP-4SFP10G-CU10M Optical
RJ-45
For more information on the transceivers that you can use with this FEX, see the Cisco Transceiver
Modules Compatibility Information at
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-suppor
t-tables-list.html.
Figure 3-10
Figure 3-10
5
1
2
3
Figure 3-11
connections. For the cable specifications that apply to these transceivers, see
Port
Fabric Host
Cable Interface Interface
Type (Uplink) (Downlink)
Optical X –
Optical X –
Optical X –
Optical X –
Optical X –
Optical X –
Optical X –
X –
Copper – X
shows the SFP+ optical transceiver used for uplink connections.
SFP+ Optical Transceivers and FETs
1 2
4
Receive optical bore
Transmit optical bore
Clasp shown in closed position
identifies the major features of the SFP+ copper transceiver and cable used for uplink
Specifications".
Comments
40- and 10-Gbps active optical breakout cable (16.4 feet
[5 meters])
40- and 10-Gbps active optical breakout cable (23.0 feet
[7 meters])
40- and 10-Gbps active optical breakout cable (32.8 feet
[10 meters])
40- and 10-Gbps copper breakout cable (3.3 feet [1 meter])
40- and 10-Gbps copper breakout cable (9.8 feet [3 meters])
40- and 10-Gbps copper breakout cable (16.4 feet [5 meters])
40- and 10-Gbps copper breakout cable (23.0 feet [7 meters])
40- and 10-Gbps copper breakout cable (32.8 feet [10 meters])
100/1000 Mbps Connector
3
4 Clasp shown in open position
5 Dust plug (use this to protect the bores from dust
contamination when the optical cables are removed)
Cisco Nexus 2000 Series Hardware Installation Guide
Cisco Nexus 2248TP-E FEX
Appendix C, "Cable and
3-9