Removing The Cisco Nexus Fabric Extender - Cisco Nexus 2000 Series Installation Manual

Removing and Installing Components
Note
Installing a Fan Tray
To install a fan tray, follow these steps:
Hold the fan tray with the sheet metal flange holding the connector on the bottom.
Step 1
Place the fan tray into the port-side exhaust chassis cavity so it rests on the chassis, and then push the
Step 2
fan tray into the chassis as far as it can go until the captive screw makes contact with the chassis.
Tighten the captive screw.
Step 3
Listen for the fans if the device is powered on. You should immediately hear them operating. If you do
Step 4
not hear them, ensure that the fan tray is inserted completely in the chassis and the faceplate is flush with
the outside surface of the chassis.
Step 5 Verify that the LED is green. If the LED is not green, one or more fans are faulty. If this problem occurs,
contact your customer service representative for a replacement part.
Note If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html.

Removing the Cisco Nexus Fabric Extender

The slider rail and port side exhaust rack-mount brackets do not have a stop mechanism when sliding in
Caution
and out. If the port side exhaust of the chassis is unfastened from the rack and the chassis slides forward
on the slider rails, it may slip off the end of the rails and fall out of the rack.
To remove the Cisco Nexus 2000 Series FEX from a rack, follow these steps:
Ensure that the weight of the FEX is fully supported and that the device is being held by another person.
Step 1
Turn off the power at the circuit breaker.
Step 2
Disconnect the power cord as follows:
Step 3
•
•
Disconnect all ports.
Step 4
Remove the screws that fasten the port side exhaust rack-mount brackets to the mounting rails.
Step 5
Cisco Nexus 2000 Series Hardware Installation Guide
4-22
If you remove a fan tray while the system is running, you must install the new fan tray within 1
minute to prevent overheating.
For AC power supplies, disconnect the power cord and the console cables.
For DC power supplies, disconnect the positive cable from the negative (-) terminal, and disconnect
the negative cable from the positive (+) terminal.
Chapter 4 Installing a Cisco Nexus Fabric Extender