Connections - Panasonic WV-CM1480 Operating Instructions Manual

CONNECTIONS

The connections described below should be made by qualified service personnel or system installers.
Shown below is an example of a basic system connection.
Connection with the Camera
Site
Connect the Video Output of the camera site equipment to
the VIDEO IN connectors on the rear of the monitor using
coaxial cables.
The maximum coaxial cable lengths between the cameras
are shown below.
RG-59/U
Cable
3C-2V
250 m
Recommended
cable length
(825 ft)
Connection with the VCR
• Recording on the VCR
Connect the VIDEO OUT A or B connector on the moni-
tor to the video input of the VCR with a coaxial cable.
Connect the AUDIO OUT A or B connector on the mon-
itor to the audio input of the VCR with an audio cable, if
applicable.
7
FOCUS
STANDBY
DATA ON
STANDBY
OFF
G
OUT
ON OFF
TERMINATION
AUDIO OUT VIDEO OUT
VCR
RG-6/U RG-11/U RG-15/U
5C-2V 7C-2V 10C-2V
500 m 600 m 800 m
(1 650 ft) (1 980 ft) (2 640 ft)
Video Switcher
VIDEO
B A
AUDIO
IN IN
B A
IN IN
S-VIDEO
AC IN
IN OUT OUT
OUT
VIDEO IN
• Monitoring the Playback picture
Connect the video output of the VCR to the VIDEO IN A
or B connector on the monitor with a coaxial cable.
• Monitoring the Playback audio
Connect the audio output of the VCR to the AUDIO IN A
or B connector on the monitor with an audio cable.
Multiple Monitor Connection
To monitor the same video on multiple monitors, connect
the VIDEO OUT A or B connector on the monitor to the
VIDEO IN connector of the other monitor with a coaxial
cable.
Up to 10 monitors in total can be connected in series
before signal loss occurs. Total cable length should not
exceed 150 meters (500 feet).