System Connection - Panasonic WV-CM1020 Operating Instructions Manual

SYSTEM CONNECTION

Single Monitor Connection
Connecting Cameras
1. Connect the Video Output terminal of the camera to the
Video Input Connector A or B of the monitor with a 75-
ohm coaxial cable.
Note: Keep the Power Switch in the OFF position before
connecting the camera.
Connecting VCR
Camera
VIDEO OUT
VCR
• Recording on the VCR
Connect the Video Output terminal A or B of the cam-
era, to the Video Input Connector of the VCR with a 75-
ohm coaxial cable.
6
FOCUS
VIDEO B VIDEO A AUDIO
IN IN IN
OUT OUT OUT
VIDEO
VIDEO OUT
IN
TL
• Monitoring the Playback picture
Connect the Video Input terminal A or B of the monitor
to the Video Output Connector of the VCR with a 75-
ohm coaxial cable.
• Monitoring the sound
Connect the Audio Out Terminal of VCR to the Audio
Input Connector of the monitor.
Multiple Monitor Connection
Camera
AC IN
AUDIO
1. Connect the Video Output of the camera or the VCR to
OUT
the Video Input of monitor 1 with 75-ohm a coaxial
cable.
2. Connect the Video Output of the monitor 1 to the Video
Input of the monitor 2 with 75-ohm coaxial cable.
Notes:
• Automatic termination will not function, if the con-
nections are not correct.
• Up to 10 monitors can be hooked up in this config
uration before signal loss occurs. Total cable
length should not exceed 150 m (500 feet).
Monitor (1)
VIDEO OUT
FOCUS
VIDEO B VIDEO A
IN IN
OUT OUT
VIDEO OUT
Monitor (2)
VIDEO IN
FOCUS
VIDEO B VIDEO A
IN IN
OUT OUT
To another monitor
AUDIO
IN
AC IN
OUT
AUDIO
IN
AC IN
OUT