Table of Contents
Advertisement
UPGRADING THE FIREWIRE FIRMWARE
This instruction covers the installation of a firmware upgrade to
support the Firewire card.
The upgrade is only required if the Firewire firmware revision currently
installed in the printer is less than the following:
IEEE1394:01.04
To check the current Firewire firmware revision, refer to the menu map
you have just printed. Examine the print-out in the lower right corner
of the block just below the Menu Map title. If the value is less than that
shown above, proceed with the firmware upgrade.
FIRMWARE UPGRADE
You will need your laptop PC for this task.
1.
Create a temporary folder on the hard disk of your laptop PC.
2.
Copy the following files from the CD supplied with the
Scancopier into this folder:
(a)
(b)
(c)
OkiDownloadTool.exe (the download tool)
Opusbacc.dll (library file)
DLM1394_xxxx.oki (where xxxx denotes the revision,
0025 in this example)
UPGRADING THE FIREWIRE FIRMWARE > 15
NOTE
English
Advertisement
Table of Contents
