Invacare ORBIT Service Manual page 11

DISASSEMBLY
W W W W W ARNING ARNING ARNING
ARNING ARNING
Make sure the locking pins of the quick-release
pin are fully released BEFORE operating the wheel-
chair.
The locking pins MUST be protruding past the top
of the seat plate assembly for a positive lock.
Keep locking pins clean.
10. Push in on the tip of the quick-release pin and rein-
stall in the seat/base frame plate assembly. See DE-
TAIL "A".
Locking
Button
Locking
Channel
BASE FRAME
SECTIONAL OF SEAT FRAME AND BASE FRAME
ASSEMBLED
(WITHOUT SEATING SYSTEM)
Locking
Channels
Seat Frame
Plate
FIGURE 1 - REMOVING/INSTALLING THE SEAT FRAME FROM/TO THE BASE FRAME
SEAT FRAME AND BASE FRAME DISASSEMBLED
Base Frame
Plate
Locking Buttons
Engaged
11. Pull down on quick-release pin to ensure positive
lock.
NOTE: If a seating system is being used on the wheel-
chair, refer to the seating system Owner's Manual for
installation and removal of the seating system.
12. Reinstall the existing seating system onto the
wheelchair, if so equipped.
SEAT FRAME
DETAIL "A" - SIDE VIEW
Locking
Pins
Quick-Release
Pin
Crossmember
Quick-Release
Base Frame Plate
Pin
Tip
11
PROCEDURE 2
Locking Buttons
Engage Here
Seat Frame
Plate
Top of
Seat Frame
Plate
Base Frame
Plate
Seat Frame
Plate
Crossmember
Locking
Button
Plunger
D
I
S
A
S
S
E
M
B
L
Y