Configure Your Adapter - D-Link DFE-530TX+ Quick Install Manual

Hide thumbs Also See for DFE-530TX+:

Table of Contents

Configure your Adapter

After you install your new D-Link adapter, by default, the TCP/IP

settings should be set to obtain an IP address from a DHCP server

(i.e. router) automatically. To verify your IP address, please follow

the steps below.

2000/XP: Click on Start > Run. In the run box type cmd

Windows

and click OK.

Windows Vista

/ Windows

7: Click on Start > All Programs >

Accessories > Command Prompt.

At the prompt, type ipconfig

and press Enter.

This will display the IP

address, subnet mask, and

the default gateway of your

adapter.

If the address is 0.0.0.0, check your adapter installation, security

settings, and the settings on your router. Some firewall software

programs may block a DHCP request on newly installed adapters.

If you are connecting to a wireless network at a hotspot (e.g. hotel,

coffee shop, airport), please contact an employee or administrator

to verify their wireless network settings.

For more information on setting your IP address, please refer to the

manual.

D-Link DFE-530TX+ Quick Install Guide

Table of Contents