D-Link DFE-530TX+ Quick Install Manual page 5

Software Installation
The drivers will install. Once the installation is complete, click OK.
Shut down your computer. Go to Start > Shut Down > select Shut
Down and click OK.
Once your computer is turned off, remove the power cable from
the computer. Open the case and insert the D-Link adapter into an
available PCI slot.
If you are familiar with Wake-On-
LAN, attach the cable to your
motherboard and the adapter. If you
are not using the WOL feature, do
not attach the cable.
Note: Write down the serial number
and hardware revision (e.g. A1)
before installing the adapter. If you
contact technical support, you will
need this information.
Replace the case, plug in the power cable, and power on your
computer.
5 D-Link DFE-530TX+ Quick Install Guide