Load Paper - Epson ET-2500 Start Here

5
Carefully seal the bottle using the reverse side of the
bottle tip for proper disposal.
6
Replace the ink tank cap securely.
7
Repeat the previous steps for the remaining bottles.
8
Close the ink tank unit cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution: Do not connect to your computer yet.
10
Raise the control panel and turn on the product. Wait for
the power light to stop flashing.
Note: If all the product lights are flashing, turn off the product
and check that no protective material has been left inside
the product.
Caution: Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
11
Press the button for 3 seconds until the
starts flashing, to begin charging the ink. Ink charging
takes approximately 20 minutes. Ink charging is complete
when the power light stops flashing.
Note: The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution: Do not turn off the product or load paper while the
product is charging or you'll waste ink.
3

Load paper

1
Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide the edge guide to the left.
3
Load paper, glossy or printable side up and short edge
first, against the right side of the rear paper feed slot.
4
Slide the edge guide against the paper, but not too tightly,
and flip the feeder guard back.
power light
3 seconds 20 minutes