Office Phone With Ehs; Office Phone With L50 Lifter - VXI V200 User Manual

CONNECT TO YOUR PHONE AND COMPUTER
Office Phone with EHS (sold separately)
1 . Remove the panel from the bottom of the base .
2 . Connect the base jack cable to the headset port of the phone and configure as described above .
3 . Snap the EHS onto the base unit .
4 . Connect the EHS cable to the EHS/lifter port on the base station . Refer to the EHS setup instructions for
further installation details .
Office Phone with L50 Lifter (sold separately)
1 . Connect the desk phone connection cable to the handset
port of the phone .
2 . Check "Configuration and Make a Test Call" (see above) .
3 . Attach the L50 Lifter to your phone . Refer to the L50 user's
guide for lifter setup and adjustment details .
Home (Analog) Phone
1 . Remove the panel from the bottom of the base .
2 . Connect the telephone line cord (red flag) to the "Tel Wall
Jack Port" (red dot) on the base . Plug the other end of
the cord into the line splitter .
3 . Plug the line splitter into the telephone wall jack .
4 . Connect the analog (home) phone to the other port of the
line splitter .
5 . Replace the panel on the bottom of the base station .
6 . Check "Configuration and Make a Test Call":
• Make sure the phone output on the base station is lit .
• Press the mode button until the phone LED on the
base is lit red .
• Lift the phone's handset (if cordless, activate handset) .
• Press the call control button on the headset and listen
for a dial tone in the headset . If there is no dial tone,
or the call is unclear, slide the compatibility switch
from A-G, one setting at a time until the dial tone/call
is clear .
• Dial a call on the phone as normal . Once the call is connected, you may replace the phone handset
(or turn the cordless handset off) .
– You can fine-tune the earpiece volume using the headset volume buttons .
– If additional microphone gain (speaking volume) is needed, or if you hear your voice echo in the
earpiece (excessive side tone), you can adjust this with the microphone volume buttons on the side
of the base .
• Press the call control button on the headset again to end the call .
VXi V200 User Guide
(continued)
PAGE 12