Connecting To A Wi-Fi Network Using A Pc Connected Wirelessly (Mac) - Sony SRS-ZR5 Help Manual

Help Guide
Personal Audio System
SRS-ZR5

Connecting to a Wi-Fi network using a PC connected wirelessly (Mac)

Note that the speaker should be initialized to the factory default for this connection. All BLUETOOTH device registration (pairing)
information is deleted. To use the BLUETOOTH connection after that, delete all pairing information on the iPhone/iPod touch, and
then set pairing again.
This section describes how to connect a Mac and the speaker wirelessly, then how to connect the speaker to a wireless router,
using the Mac.
Do the following before starting.
Disconnect the LAN cable (not supplied) from the speaker.
Place the speaker closer to the wireless router.
Locate the SSID (the name of a wireless network) and encryption key (WEP or WPA), which are required to set up a Wi-Fi
network. The encryption key restricts access to devices on a network. It is used to make more secure communication between
the devices connected to wireless routers and access points.
Have the Wi-Fi network name (SSID) and password (encryption key) of the wireless router available for
1
reference.
For details, refer to the operating instructions supplied with your wireless router.
With the speaker turned on, press and hold the – (volume) button and the
2
at the same time for more than 4 seconds to initialize the settings of the speaker.
The power of the speaker turns off automatically. The settings of the speaker return to their factory defaults, and network
settings and all BLUETOOTH device registration (pairing) information are deleted.
Turn on the speaker.
3
Connect the speaker to the Mac.
4
(power)/ PAIRING button
11