Connecting To A Wi-Fi Network Using The Wi-Fi Protected Setup (Wps) Button Of The Wireless Router - Sony SRS-ZR5 Help Manual

Help Guide
Personal Audio System
SRS-ZR5
Connecting to a Wi-Fi network using the Wi-Fi Protected Setup (WPS) button of
the wireless router
If your wireless router has a Wi-Fi Protected Setup (WPS) button, you can connect to the Wi-Fi network by this method.
To check if your wireless router is compatible with Wi-Fi Protected Setup (WPS), refer to the operating instructions of your router.
Do the following before starting.
Disconnect the LAN cable (not supplied) from the speaker.
Place the speaker closer to the wireless router.
Turn on the speaker.
1
Press and hold the UPDATE/WPS button on the rear of the speaker until a beep is heard (for about 2
2
seconds).
The LINK indicator flashes in orange and the NETWORK indicator lights up.
Press the Wi-Fi Protected Setup (WPS) button* of the wireless router.
3
Operate within 90 seconds after pressing the UPDATE/WPS button of the speaker. Depending on the wireless router, press
and hold the Wi-Fi Protected Setup (WPS) button of the wireless router for a few seconds. For details, refer to the operating
instructions of your wireless router.
*
92