Table of Contents
Advertisement
5. Connect the previously selected resistor from terminal #87 to the second (#2) wire (as shown).
NOTE: The above information and following diagram is for the GM VATS system only. For GM PASS
LOCK System you will require the Audiovox AS-PASS II Module.
Green w/White trace Wire: Entry Illumination Ground Output
This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to disarm
the alarm or to unlock the doors and provides a continuous pulsed output whenever the alarm is trig-
gered. This wire should be connected to an external relay, and wired to the vehicles interior entry
lighting whenever the optional Interior Illumination circuit is desired. See below for relay wiring details.
Grey w/Black Trace Wire: Negative Inhibit Input
The Grey w/Black Trace wire provides an instant shutdown for the Remote Start Control Module
whenever it is grounded. Connect the Grey w/Black trace wire to the hood pin switch previously
installed. This wire must be routed through a grommet in the firewall and connected to the hood pin
switch. If the pin switch is to be used with an alarm system, connect this wire using the diode assembly
provided.
IMPORTANT! This connection is a safety wire and must be connected as shown and tested as
specified. Failure to do so may result in personal injury or property damage. See detail
of wiring in the following diagram. This wire may also be used if the vehicle brake light
circuit switches ground to the brake lights. An isolation diode must be used for ground
switched brake light circuits and must be connected to the output of the brake switch.
Grey w/Black Trace Negative Inhibit Safety Shut Down Detail
Entry Illumination Detail
9
Advertisement
Table of Contents
