Table of Contents
Advertisement
SIREN
Purple Wire: (+) Door Trigger Input
If the vehicle's door courtesy light switches + 12 volts when the door is opened, (Some Fords and some
Imports), you must connect this wire to the positive output from one of the vehicle's door pin switches.
In most cases, the Purple wire will need to be connected to only one door switch no matter how many
doors the vehicle has as most door lighting circuits are wired in parallel. This wire will be shunted when
remote starting the vehicle and will remain shunted, if active, while running under command of the
remote start. If this wire is active when the system is armed, the siren will emit three chirps. When the
zone clears, the siren will emit 1 chirp to confirm full arming. See below for wiring details.
Dark Green Wire: (-) Instant Trigger Input
This is the instant on ground trigger input wire. This wire must be connected to the hood and trunk pin
switches previously installed.
Note: This wire will be shunted when remote control channel 2 is accessed, (trunk release). This wire
will remain shunted all the while there is ground present and for 5 seconds after the ground is
removed. This allows the operator to open the trunk via the remote transmitter without having to
first disarm the alarm system. See below for wiring detail.
Siren Wiring Detail
TO WHITE w/BLACK WIRE OF MODULE
RED
l
BLACK
Positive Door Switch Wiring Detail
Hood Pin Switch Detail
7
(-) TO VEHICLE'S CHASSIS GROUND
Advertisement
Table of Contents
