Part Identification Chart - Pro-Form Endurance 720 E User Manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M5 Washer
M10 Split
M8 Washer 16mm Wave
M8 Locknut
(94)–2
(97)–8 Washer (105)–8 Washer (54)–2
(102)–4
M4 x 16mm M8 x 14mm
#8 x 12mm M8 x 13mm
Screw (101)–16 Screw (111)–4
Shoulder Screw (82)–6
Screw (126)–2
M8 x 38mm
M10 x 25mm
Bolt (96)–4 Screw (99)–4
M10 x 122mm
Screw (104)–4
6