Panasonic KX-TDA15 Installation Manual page 135

3.3 Installation of the KX-TDA30 Maintenance Console
1. Connect the PC to the Hybrid IP-PBX with a USB cable.
2. Start the KX-TDA30 Maintenance Console from the Start
menu.
3. Type the Installer Level Programmer Code (default: 1234),
then click [OK].
The Programmer Code authorises different programming
levels, and the Quick Setup is only available when you start
the KX-TDA30 Maintenance Console with the Installer
Level Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorisation: Administrator Level (default: 1111), and
User Level (default: none).
4. Click "Connect" → "USB" from the menu bar.
5. Type the system password for installer (default: 1234), then
click [OK] to log-in.
6. When country/area data do not match:
a.
Click [OK] to replace the country/area data of the
Hybrid IP-PBX. Replacement may take several
minutes to complete.
b.
Follow the procedure described in "2.10.1 Starting the
Hybrid IP-PBX" and restart the Hybrid IP-PBX.
c.
Repeat steps 4 to 5 to reconnect the KX-TDA30
Maintenance Console to the Hybrid IP-PBX.
Installation Manual 135