2.10 Starting the Hybrid IP-PBX
5.
While the RUN indicator is flashing, return the System Initialise Switch to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and be kept lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for the IP-GW4
card) will be initialised to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW4 card will not be initialised.
Note
Use the same types of AC adaptor and AC cord that are supplied with the Hybrid IP-PBX only.
LED Indications
Indication
RUN
ALARM
Confirming the Trunk Connection
After initialisation, programme the Hybrid IP-PBX and establish trunk connection, and then use a PT to
confirm it.
To confirm, dial [ ] [3] [7] + trunk number (3 digits) or press S-CO button. You will hear a dial tone if the trunk
is available and connected.
Turning off the Hybrid IP-PBX
For safety reasons, make sure to turn off the power switch before unplugging the Hybrid IP-PBX. To unplug,
follow the reverse steps to plug it in.
128
Installation Manual
Colour
Description
Green
PBX status indication
•
OFF: Power Off (includes normal reset)
•
ON: Power On and running (on-line)
•
Flashing (60 times per minute): Starting up
•
Flashing (120 times per minute): Starting up or resetting with:
•
•
Red
Alarm indication
•
OFF: Normal
•
ON: Alarm (CPU stop, alarm for each card)
•
Flashing: Alarm (MPR file error in restarting)
the System Initialise Switch in "SYSTEM INITIALIZE"
position
the SD Memory Card not inserted