Panasonic KX-TDA15 Installation Manual page 120

2.8 Connection of Doorphones, Door Openers, External Sensors, and External Relays
Connection of Door Openers, External Sensors, and External Relays to
DPH4 Card
Use 8-pin and 10-pin terminal block (included with the card) for connection.
1.
While pressing down on the hole at the top of the terminal block using a screwdriver, insert the wire into
the side hole as shown below. Repeat this procedure for other door openers, external sensors, and
external relays.
Refer to "2.5.1 DPH4 Card" for pin assignments.
Door Opener
External Sensor/
External Relay Device
2.
Attach the terminal block to the connector of the DPH4 card in the Hybrid IP-PBX.
120 Installation Manual
To door openers/
external relays
To external sensors