Kaiser Baas GAMMA User Manual page 15

Obstacle Avoidance Assembly:
1. Match the Obstacle Avoidance Module to the bottom of the Drone
2. Push and slide the Module according to the diagram. The Module will click into place.
3. Refer to the flight modes section for further instruction.
Rotor Blades Assembly:
It is important that only Kaiser Baas Gamma Drone Rotor Blades are fitted to the Gamma
Drone. Never use any third party accessories or tools.
Your Drone will come ready to fly with Rotor Blades attached. If you need to replace
them, please refer to the following guide:
Disassembly:
1. Use the provided screwdriver to untighten the
screw in an anti-clockwise direction.
2. Remove the Rotor Blade by pulling up and off
the motor axis bar.
Assembly:
1. Insert the Rotor Blade onto the motor axis bar.
2. Only install the Rotor Blades to the corresponding
clockwise/anti-clockwise
marked on each blade to indicate which motor
it should go on. Incorrect installation will cause
severe instability. Refer to the diagram
3. Use the provided screwdriver to tighten the
screws in a clockwise direction.
[WARNING] Never use Rotor Blades with any
signs of damage or wear and tear. This includes
chips, scratches and cracks. Damaged Rotor
Blades can cause the Drone to fail in-flight and
may result in damage to persons or property.
[WARNING] Never touch the Drone or the Rotor
Blades when the motors are spinning.
motor. A letter is
GAMMA DRONE | User Guide
15