D-Link DCS-3410 User Manual page 54

Section 5 - Troubleshooting
8. Can the DCS-3410 be connected to the network if it consists of only private IP addresses?
Yes, the Network Camera can be connected to a LAN with private IP addresses.
9. Can the DCS-3410 be installed and work if a firewall exists on the network?
If a firewall exists on the network, port 80 is open for ordinary data communication. The DCS-3410 uses port 5002
for streaming audio and port 5003 for streaming video. These ports (or the ports you specify from the Advanced
Tab in the Configuration screen if you change the default ports) need to be opened on the firewall.
10. Why am I unable to access the DCS-3410 from a Web browser?
If a router or firewall is used on the network, the correct ports for the DCS-3410 may not be configured on the
router or firewall. To correct the problem, you need to determine if the DCS-3410 is behind a router or firewall and
if the router or firewall is properly configured for the ports the DCS-3410 is using. Other possible problems might be
due to the network cable. Try replacing your network cable. Test the network interface of the product by connecting
a local computer to the unit, utilizing a Ethernet crossover cable. If the problem is not solved the Network Camera
might be faulty.
11. Why does the Network Camera work locally but not externally?
This might be caused by network firewall protection. The firewall may need to have some settings changed in
order for the Network Camera to be accessible outside your local LAN. Check with the Network Administrator for
your network.
Make sure that the Network Camera isn't conflicting with any Web server you may have running on your network.
The default router setting might be a possible reason. Check that the configuration of the router settings allow the
Network Camera to be accessed outside your local LAN.
12. I connected the Network Camera directly to a computer with a cross-over cable Ethernet cable and
received the following Windows error upon running the Installation Wizard:
This Windows error will occur if the Network Camera is connected to a computer that is not properly configured
with a valid IP address. Turn off DHCP from the Network Settings in Windows and configure the computer with a
valid IP address, or connect the camera to a router with DHCP enabled. This error can also occur if the Installation
Wizard icon is clicked on more than once from the setup wizard.
D-Link DCS-3410 User Manual 54