Table of Contents
Advertisement
CHAPTER 1: INTRODUCTION
HOW TO USE THIS MANUAL
Make sure to read these instructions in their entirety before
configuring an MDM-832. In particular, pay close attention
to material related to safety issues.
As you read these instructions, you will encounter the fol-
lowing icons for notes, tips, and cautions:
NOTE:
A note identifies an important or useful
piece of information relating to the topic under
discussion.
TIP:
A tip offers a helpful tip relevant to the topic
at hand.
CAUTION:
A caution gives notice that an
action may have serious consequences and
could cause harm to equipment or personnel, or
could cause delays or other problems.
Information and specifications are subject to change.
Updates and supplementary information are available at
www.meyersound.com.
Meyer Sound Technical Support is available at:
■
Tel: +1 510 486.1166
■
Tel: +1 510 486.0657 (after hours support)
■
Web:
www.meyersound.com/support
■
Email:
techsupport@meyersound.com
MDM-832 DISTRIBUTION MODULE
The MDM-832 distribution module routes up to eight chan-
nels of AC power, balanced audio, and RMS™ to multiple
Meyer Sound self-powered loudspeakers, further enhancing
portability and ease of use for self-powered on-stage moni-
tors or loudspeaker systems. Third-party composite cables
are available to distribute both AC power and balanced
audio with a single cable, streamlining setups and tear-
downs.
MDM-832 Front Panel (Shown with XLR 5-pin Output Connectors)
MDM-832 Rear Panel
The MDM-832 simplifies distribution by reducing cable clut-
ter in systems that require a reduced footprint, such as on-
stage monitoring.
The MDM-832 receives balanced audio from eight rear-
panel XLR 3-pin female input connectors and routes the
audio to eight front-panel XLR male output connectors.
Audio outputs are available as XLR 3-pin or XLR 5-pin con-
nectors. 3-pin connectors carry balanced audio. 5-pin con-
nectors allow the use of third-party composite cables
carrying both balanced audio and RMS. The rear panel
includes an RMS network connector (and terminator) for
routing RMS signals from the eight front-panel RMS con-
nectors.
AC power is received from a single rear-panel
®
powerCON
32 connector and routed to two sections, each
with four front-panel powerCON 20 connectors.
5
Advertisement
Table of Contents
