Table of Contents
Advertisement
APPENDIX B: ORIENTING THE MDM-832 RACKMOUNT BRACKETS
The MDM-832 ships with its reversible rackmount brackets
in a front-facing flush position. The rackmount brackets can
be oriented to recess the distribution module from the rack
face, position the front panel of the distribution module at
the rear of the rack, or position and recess the front panel of
the distribution module at the rear of the rack.
To orient the MDM-832 rackmount brackets:
1. Use a #2 Phillips screwdriver to remove the four screws
from each rackmount bracket.
2. Do one of the following:
To mount the module with the front panel recessed, slide
■
the rackmount brackets forward until the rear sets of
screw holes line up with the screw holes in the chassis.
■
To mount the module with the rear panel at the front of
the rack, rotate the rackmount brackets to face the rear
panel, then adjust so the front sets of screw holes line up
with the screw holes in the chassis.
To mount the module with the rear panel in a recessed
■
position at the front of the rack, rotate the rackmount
brackets to face the rear panel, then adjust so the rear
sets of screw holes line up with the screw holes in the
chassis.
3. Use a #2 Phillips screwdriver to re-install the screws to
secure the rackmount brackets to the enclosure.
TIP:
Use of Loctite
strength, removable thread-locking adhesive is
recommended for secure and non-permanent instal-
lation of the rackmount bracket screws.
4. Secure the MDM-832 to the rack rails with four 10-32
truss head screws.
®
243 or equivalent medium-
29
Advertisement
Table of Contents
