Jump-Starting Procedures; Preparations For Jump-Start - Dodge DART 2015 Owner's Manual

Hide thumbs Also See for DART 2015:

Table of Contents

lug bolt torque. If in doubt about the correct tightness,

have them checked with a torque wrench by your

authorized dealer or service station.

5. Lower the jack until it is free. Remove the wheel

blocks. Reassemble the lug wrench to the jack assem-

bly and stow it in the spare tire area. Secure the

assembly using the means provided. Release the park-

ing brake before driving the vehicle.

6. After 25 miles (40 km) check the wheel bolt torque

with a torque wrench to ensure that all wheel bolts are

properly seated against the wheel.

JUMP-STARTING PROCEDURES

If your vehicle has a discharged battery it can be jump-

started using a set of jumper cables and a battery in

another vehicle or by using a portable battery booster

pack. Jump-starting can be dangerous if done improperly

so please follow the procedures in this section carefully.

WHAT TO DO IN EMERGENCIES 539

NOTE: When using a portable battery booster pack

follow the manufacturer's operating instructions and

precautions.

Do not use a portable battery booster pack or any

other booster source with a system voltage greater

than 12 Volts or damage to the battery, starter motor,

alternator or electrical system may occur.

Do not attempt jump-starting if the battery is frozen.

It could rupture or explode and cause personal injury.

The battery in your vehicle is located in the front of the

engine compartment, behind the left headlight assembly.

Table of Contents