Updating The Phone Firmware - Gigaset A510IP Manual

Setting the base
If there is new provider data, the idle display on the handset displays the message
New profile available. The f message key flashes.
f
§OK§
~
The new data for your VoIP provider will be downloaded and saved on the phone.
A profile update will only be started if no other profile or firmware update is taking
place at the time.

Updating the phone firmware

Prerequisite: The phone is connected to the Internet (i.e., connected to a router,
¢
page
If necessary, you can update your phone's firmware.
The firmware update is downloaded directly from the Internet by default. The rele-
vant Web page is preconfigured in your phone.
Prerequisite:
The phone is in idle status i.e.,
u
No calls are being made.
u
There is no internal connection between the registered handsets.
u
The base menu is not open in any of the handsets.
Starting the firmware update manually
¤
§Menu§
~
The phone establishes a connection to the Internet.
§Yes§
Please note
u
The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u
When updating from the Internet, checks are made to ensure that no newer
version of the firmware exists. If this is not the case, the operation is termi-
nated and a message is issued to that effect.
u
During the update, the handsets temporarily lose their connection to the
base. The base is restarted.
u
You can also reset the firmware via the Web configurator, i.e., reload the pre-
vious firmware version or the firmware version that was loaded as default to
the phone.
102
Press the key.
Press the display key to confirm the subsequent prompt.
If the system PIN is not 0000: enter the system PIN and press
21).
¤
Ï Settings
System
Select and press
If the system PIN is not 0000: enter the system PIN and press
Press the display key to start the firmware update.
¤
Firmware Update
§OK§
.
§OK§
.
§OK§
.