Important Electrical Instructions; Important Operation Instructions - Fuel Fitness FE48 ELLIPTICAL Owner's Manual

IMPORTANT ELECTRICAL INSTRUCTIONS

WARNING!
• NEVER remove any cover without first disconnecting AC
power supply.
• If A.C. voltage varies by ten percent (10%) or more, the
performance of your elliptical may be affected. Such conditions
are not covered under your warranty. If you suspect the voltage is
low, contact your local power company or a licensed electrician
for proper testing.
• NEVER expose this elliptical to rain or moisture. This product is
NOT designed for use outdoors, near a pool or spa, or in any
other high humid- ity environment. Maximum environmental
ratings are 40-120 degrees Fahrenheit, 95% humidity non-condensing
(no water droplets forming on surfaces).

IMPORTANT OPERATION INSTRUCTIONS

NEVER operate this elliptical without reading and completely understanding the results of any

operational change you request from the computer.
Understand that changes in resistance do not occur immediately. Set your desired level on the

computer console and release the adjustment key. The computer will obey the command
gradually.
NEVER use your elliptical during an electrical storm. Surges may occur in your household

power supply that could damage elliptical components.
Use caution while participating in other activities while using your elliptical such as watching

television, reading, etc. These distractions may cause you to lose balance, resulting in serious
injury.
Always hold on to a handlebar while making control changes.

TRANSPORTATION
The elliptical is equipped with transport wheels, which are engaged when the rear of the
elliptical is lifted.
EXITING DISPLAY MODE
This product is preset to a DISPLAY MODE that keeps the console continually powered on. To turn this
feature off and allow your display to go into DISPLAY MODE when not being used, please use the follow-
ing procedure:
1. When in stand-by status, hold Start, Stop and Enter keys for five seconds to enter the Engineering
Mode.
2. Use the / keys to choose SELECT FUNCTION, then press the ENTER key.
3. Use the / keys to select the DISPLAY MODE, then press Enter key.
4. Use the / keys to turn ON or OFF the DISPLAY MODE function.
5. Hold the Stop key to save and exit Engineering Mode.
3
Plug-In
FE48 ELLIPTICAL