Appendix B Fault Codes - Hoveround HD6 Owner's Manual

Appendix B: Fault Codes
The microprocessor checks various features within the controller and will
display any fault indication. The controller may prevent the chair from
driving if a critical fault condition exists.
If a fault occurs, you can find out what has happened by counting the
number of bars on the battery gauge that are flashing.
1 bar: Low battery or a bad connection. Try recharging the battery.
2 bars: Bad connection to left motor.
3 bars: Short circuit, left motor to battery.
4 bars: Bad connection to right motor.
5 bars: Short circuit, right motor to battery.
6 bars: Verify battery charger is not plugged in.
D82014014B 10/15
When there is a fault please follow this procedure:
A. Switch off the control system.
B. Make sure that all connectors on the chair and
the control system are connected securely. Make
sure brake release levers are in the drive position.
C. Switch on the control system again and try to drive
the chair. If the fault occurs again, switch off and do
not try to use the wheelchair. Contact Hoveround
Support 1-800-96-HOVER (1-800-964-6837)
Fault Code Lights
Figure 11
Fault Code Lights
®
Chapter 11 49