Display Settings; Troubleshooting - Kenwood KMM-BT502DAB Instruction Manual

DISPLAY SETTINGS

Set the dimmer
Press and hold DISP (DIMMER) to turn on or off the dimmer.
• If you have set [DIMMER TIME], it will be canceled once you press and
hold this button.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DISPLAY], then press the knob.
3
Turn the volume knob to select an item (see the following
table), then press the knob.
4 3
Repeat step until the desired item is selected/activated or
follow the instructions stated on the selected item.
5
Press and hold to exit.
To return to the previous setting item, press
DIMMER Dim the display illumination.
ON: Dimmer is turned on. ; OFF: Cancels.
DIMMER TIME: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the
knob.
2 Turn the volume knob to adjust the [OFF] time, then press the
knob.
(Default: [ON]: 18:00; [OFF]: 6:00)
BRIGHTNESS 0 — 31: Select your preferred brightness level for display
illumination.
TEXT SCROLL AUTO/ ONCE: Select whether to scroll the display information
automatically, or scroll only once. ; OFF: Cancels.
20

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
The unit does not work at all.
.
DAB reception is poor.
Default: XX
"DAB ANT ERR"
"RELATED SERV FOUND"
• Radio reception is poor.
• Static noise while listening to
"READING" keeps flashing.
Elapsed playing time is not
correct.
"LOADING" appears when you
enter search mode by pressing
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated properly.
Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 22)
display is incorrect.
Reset the unit. ( 3)
Make sure [ON] is selected for [DAB ANT POWER].
( 4)
Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF].
( 4)
• Press the volume knob to activate Soft-Link. ( 7)
• Press
Connect the antenna firmly.
the radio.
Do not use too many hierarchical levels or folders.
This is caused by how the files are recorded.
This unit is still preparing the iPod/iPhone music list.
It may take some time to load, try again later.
.
to cancel.