Lighting Instructions - Napoleon LA400RSIB Instructions Manual

6

Lighting Instructions

EN
WARNING!
WARNING!
supply valve.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Left Rear
Left Centre
Burner Burner
Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas
Main Burner
Lighting
1. Open grill lid.
step 2 several times.
burner control knob until the burner
4. If the burner does not ignite, then
or light with a match.
5. If the burner will not ignite within
the 'off' position and wait 5 minutes
valve to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Right Centre
Right
Burner
Burner
Rear Burner Lighting
(Rotisserie Burner) (if equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie
burner control knob slowly to the
'hi' position. This action will ignite
the pilot flame which will in turn
light the burner. If the pilot lights,
continue to push down on the
lights then release.
immediately turn the control knob
back to the 'off' position and repeat
step 3 several times.
5 seconds, turn the control knob to
for any excess gas to dissipate.
Either repeat steps 3 and 4 or light
with a match.
Side Burner
Side Burner Igniter
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner
control to high position.
3. Press and hold igniter button
until burner lights, or light by
match.
4. If the burner will not ignite
within 5 seconds, turn the control
knob to the 'off' position and wait
5 minutes for any excess gas to
dissipate. Either repeat steps 2
and 3 or light with a match.