System Report; System And Components; Installation - Lorentz PS200 Installation Operation & Maintenance

13

System Report

13.1

System and Components

Date of purchase
Dealer
(full contact details)
System voltage
Battery system
Quantity of solar modules
Solar module brand
Module model #
Controller model
other, i.e.:
Controller serial #
Pump end model #
Pump end serial #
Motor model #
Motor serial #
Temperature Range
Helical rotor pumps (without "C" in the model number) work optimally only in a specific
temperature range. Last digit of pump end model # indicates temperature class.
If a special temperature range was not specified, the last digit of model number will be 1.
Class 0 32 °F to 54 °F
Class 1 46 °F to 72 °F
Class 2 64 °F to 90 °F
Class 3 82 °F to 108 °F
Class 4 100 °F to 126 °F
page 50 | v100820
yes no
PS1800 PS1200
PS600
PS200
0 °C to 12 °C
8 °C to 22 °C (Class 1 is the standard class)
18 °C to 32 °C
28 °C to 42 °C
38 °C to 52 °C
Errors excepted and possible alterations without prior notice.
13.2

Installation

Installation date
Installer
(full contact details)
V Well depth
Pump depth
Additional vertical lift (to top of tank)
Static water level
Drawdown level
Drop pipe (vertical from the pump)
Size
Type
Length
Additional pipe length (to tank)
Size
Type
Length
Submersible pump cable
Wire size
Length (controller to pump)
Max. RPM control
Factory setting is maximum.
If this setting was reduced,
enter setting here:
m | ft
m | ft
m | ft
m | ft
m | ft
mm | in
2
m | ft
mm | in
2
m | ft
mm 2 | AWG
m | ft
yes no
Manual | LORENTZ PS Pump Systems