Sanyo DC F200 Instruction Manual page 8

Checking the programme
Each time the MEMORY button is pressed in the stop mode, the
programmed details sequentially appear on the display.
Changing a programme
To add a new selection to a programme:
1. In the stop mode, press the MEMORY button repeatedly until"- - --
.- -" is displayed.
2. Select a disc and track number as explained above.
3.' Press the MEMORY button.
To change a selection:
1. In the stop mode, press the MEMORY button repeatedly until the
selection to be replaced is displayed.
2. Select a disc and track number as explained above.
3. Press the MEMORY button.
Note:
Programmed details cannot be partially deleted or inserted.
LISTENING
Deck A is for playback only; deck B is for both playback and recording.
Do not turn the unit off while the tape is running. Otherwise, the pinch roller
may be damaged.
1.
2.
3.
4.
5.
Select 'TAPE. "TN appears on the display.
Press the STOP/EJECT button to open the cassette holder.
L
o
0
mm
After the cassette has been loaded, push the cassette holder back into
position.
Press the PLAY button (Deck A or Deck B) to begin playback.
Press the STOP/EJECT button to stop playback at any time. Press it
again to remove the cassette.
When the end of the tape has been reached, automatic stop will be
activated.
WHAT TO DO IF ...
If "E-dLSC appears.
1. Press the POWER button to turn the power off.
2. Press the POWER button to turn the power on.
If the operation of the unit or display is not normal, even though the
appropriate buttons have been pressed.
1. Disconnect the mains lead.
2. Press the RESET button (rear of the unit) for 30 seconds or more.
3. Connect the mains lead.
4. Press the POWER button to turn the power on.
5. Press the desired function button.
Note:
If the unit does not operate correctly, or "E-dlSC appears again,
Dlease contact your nearest SANYO Authorized Service Centre.
TO TAPES
Note:
Endless tapes cannot be used.
Do not use C-120 tapes. They may jam in the mechanism.
Pause (Deck B)
Press the PAUSE button to temporarily stop playback or recording. Press
it again to resume operation.
Fast forward and rewind
Press the F FWD or REW button.
When the tape has been wound to the end, the deck stops automatically.
Note:
While playing or recording, do not press the F FWD or REW button of the
other deck, or the sound quality may deteriorate.
Sequential playback (From deck A to deck B)
1.
2.
3.
Press the PLAY button on deck A. Deck A playback will begin.
Press the PAUSE button on deck B.
Press the PLAY button on deck B. Deck B enters the pause mode.
When the tape automatically stops on deck A, deck B playback will
begin.
When the end of the tape has been reached on deck B, automatic stop
will be activated.
7