Sanyo DC F200 Instruction Manual page 3

CONNECTIONS
FM outdoor aerial
4M loop aerial
FM indoor aerial
1
Video equipment
Do not connect the mains lead toan ACoutlet until all connections
have been made.
Before connecting the mains lead, set the POWER button on the
front panel to@ (button out).
The system is not completely disconnected from the mains when
the POWER button is set to the U position.
I
When the unit is first connected, the display switches automatically to
the demonstration mode. To cancel this mode, turn the power on.
I
Speakers
Connect the connector of the left speaker lead to the '(L" SPEAKERS
socket and the connector of the right speaker lead to the "R" socket.
If you have difficulty inserting the speaker lead connector, turn it over and
reinsert it.
FM aerial
The FM indoor aerial is sufficient to receive most local FM broadcasts and
should be connected to the EXT. ANT terminal. Extend the aerial wire as
straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM outdoor
aerial (not supplied) should be connected instead of the indoor aerial. The
terminals will accept 75-ohm coaxial cable. Consult your dealer.
AM loop aerial
Assemble the loop aerial as shown in
figure.
Q
@—
L
@ ""~ #@j
(\\
\\\
?,/5 /'
\=\._////, /
\
-—-=
o
2
- 'OanAcOut'e'
Unwind the aerial wires, then connect them to the AM LOOP ANT
terminals. Place the loop aerial in a position which yields the best AM
reception, or attach it to a wall or other surface as shown in figure.
upplied)
Note:
To minimize noise, the speaker, mains and any other leads should not
come close to the FM indoor or outdoor aerial lead and AM loop aerial. Do
not place the aerial leads close to the system.
Video equipment
Connect leads (not supplied) from the audio output sockets of a video
equipment to the VIDEO sockets.
Headphones
Connect stereo headphones (not supplied) to the PHONES socket for
monitoring or for private listening. The speakers are automatically
disconnected when headphones are connected.
2