Freestyle MN126-1 Service Manual page 20

The incorrect use of AirBelt can cause it to get hot, ignite, and may cause serious injury. Be
sure not to pierce, strike, step on, or drop the battery, or otherwise subject the battery to strong
impacts or shocks.
To charge the AirBelt battery:
1) Release safetycap from end of the AirBelt cord.
2) Connect the AC/DC power supply (included with the AirBelt Accessory kit) to the end of AirBelts
power cord as shown in Figure 12.
3) Connect the AirBelt power supply to an AC electrical outlet to recharge.
Replace safety cap on AirBelt cord when not in use.
Do not attempt to charge the optional AirBelt with the any other power supply or the AirBelt can
be damaged. Use only the AirBelt power supply provided to charge AirBelt.

The FreeStyle AirBelt will completely recharge from its fully depleted state in approximately 3 ½ hours.

While charging a fully discharged battery, the LED will continue to blink until 25% capacity is reached. The
LED will then turn solid.

Each of the four LEDs, 25% -100%, will blink as stated above, then turn solid when
it's capacity
.

When all LEDs illuminate solid, the battery is fully charged and the LEDs will remain solid for a period of
time, then all four LEDs will turn off.
3-2
Figure 3.2: AirBelt Battery Charging set up
AirBelt
Connecting the AirBelt cord to the power supply cord
AC/DC Power Supply
PW009-2
AC/DC Power
Supply
PW009-2 AC/DC Power Supply
PW009-2 AC/DC Power Supply
the battery reaches
FreeStyle Service Manual MN126-1 E
F
i
g
u
r
e
4