Audiovox PRO 2000 Short Manual

RF Programmable Features :
Feature Selection 1 Chirp
1st DoorL/UL 1 Sec.
2nd Accy Lock Auto Lock On
3rd Accy. UL Auto UL Dr
4th Passive Locks Passive
5th Pass/Act Arm Passive Arm
6th Voltage Sense On
7th Siren/Horn O/P Siren&Horn
8th Horn Chirp 10ms
9th Override Method Custom Code
10th Two Step Unlock On
11th Chp. From Tx. On
12th Keyless Or Alarm Keyless
To program these selectable features;
Action
Turn ignition on
Press and release the valet switch 3 times
Within 3 seconds, turn ignition Off
First Then On
Press transmitter Lock button to change
Press transmitter Lock button to change
Press transmitter Lock button to change
Press transmitter Lock button to change
Second Press and release the valet switch
Press transmitter Lock button to change
Third Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Fourth Press and release the valet switch
Press transmitter Lock button to change
Fifth Press and release the valet switch
Press transmitter Lock button to change
Sixth Press and release the valet switch
Press transmitter Lock button to change
Seventh Press and release the valet switch
Press transmitter Lock button to change
Press transmitter lock button to change
Eight Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Press transmitter Lock button to change
Press transmitter Lock button to change
Ninth Press and release the valet switch
Press transmitter Lock button to change
Tenth Press and release the valet switch
Press transmitter Lock button to change
Eleventh Press and release the valet switch
Press transmitter Lock button to change
Twelfth Press and release the valet switch
Press transmitter Lock button to change
Press and release the valet switch
Turn ignition key off
Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming will be
terminated.
Note: This system allows the transmitter to be programmed for single button lock/unlock or separate button lock/unlock. The receiver is set up as
follows:
Channel #1 = Lock/Unlock/Unlock 2 & Panic (Unlock only if no button is programmed to Ch.2)
Channel #2 = If Programmed, Unlock/Unlock 2 & Panic
Channel #3 = Channel 3 & Alternate Channel 3
Channel #4 = Channel 4 Output
Channel #5 = Channel 5 Output (If so Equipped)
Released 7-24-01.
2 Chirps 3 Chirps
3.5 Sec. 1 Sec L, Dbl. U/L
Auto Lock Off
Auto UL All Auto UL Off
Active
Active Arm
O f f
Siren Only Horn Only
16ms 30ms
Valet
O f f
O f f
Alarm
System Response
No response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
3 chirps = 1 sec. lock, dbl 1 sec. unlock
4 chirps = 1 sec. unlock, dbl 1 sec. lock
5 chirps = dbl 1 sec. lock, dbl 1 sec. unlock
or
2 chirps = auto locks off
1 chirp = auto locks on
or
3 chirps = auto unlock off
1 chirp = auto unlock drivers door only
2 chirps = auto unlock all doors
or
2 chirps = active door locks
1 chirp = passive door locks
or
2 chirps = active arming
1 chirp = passive arming
or
2 chirps = voltage sense off
1 chirp = voltage sense on
or
1 chirp = siren and horn output
2 chirps = siren output only
3 chirps = horn output only
or
2 chirps = horn chirp output 16mS
3 chirps = horn chirp output 30mS
4 chirp = horn chirp output 40 mS
5 chirps = horn chirp output 50mS
1 chirp = horn chirp output 10 mS
or
2 chirps = valet switch override operation
1 chirp = custom code override operation
or
2 chirps = 2 step unlock off
1 chirp = 2 step unlock on
or
2 chirps = chirp delete from transmitter inactive
1 chirp = chirp delete from transmitter active
or
1 chirp = keyless entry mode
2 chirp = alarm mode
or
Exit program mode
or
Exit program mode
Model PRO 2000
Short Manual
4 Chirps 5Chirps
Dbl L, 1 Sec U/L Dbl L, Dbl U/L
40ms 50ms
Default
1 Sec.
O f f
O f f
Active
Active
O f f
S&H
16ms
Valet
O f f
O f f
Keyless
128-6103
Front Page