Kärcher DE 4002 Operating Instructions Manual page 4

DE 4002
1 Steam pistol
2 Handwheel for steam control
3 Release button
4 Locking mechanism (child lock)
5 Steam switch
6 Modular accessory plug
7 Reset button – Descaling completed
8 VAPOHYDRO control knob
9 Temperature indicator
10 Steam control knob
11 Indicator light – Descaling due (white)
12 Indicator lamp –
Low water warning, additional tank (red)
13 Indicator lamp – Heater (yellow)
14 Heater ON/OFF switch
15 Steam supply switch
16 Indicator lamp –
Low water warning, boiler (red)
17 Boiler cap with safety valve
18 Tank cap
19 Funnel for filling tank
20 Extension tubes
21 Spot nozzle
22 Circular brush
23 Extension
24 Power nozzle (red)
25 Hand nozzle
26 Terry-towelling slip-on
27 Floor nozzle
28 Large wiping cloth
29 Retaining bracket
30 Floor Nozzle Storage Fitment
For the sake of the environment
The packaging material can be recycled.
Please do not place the packaging into the
ordinary refuse for disposal, but arrange for
the proper recycling.
Old appliances contain valuable materials
that can be recycled. Please arrange for the
proper recycling of old appliances. Batteries,
oil, and similar substances must not enter the
environment. Please dispose of your old appliances
using appropriate collec-tion systems.
4
1. Starting the unit
1.1 Unpacking the unit
• If you notice any transport damage while
unpacking the unit, please report it to your dealer
immediately.
1.2 Attaching the accessories
• Connect the modular accessory plug to the main
unit. The lugs on the plug must lock into place on
the cover of the main unit socket.
• Attach the required accessory (floor, hand or spot
nozzle) to the steam gun. Push both parts
together until the lock button on the steam gun
snaps into place.
• If required, use the extension tubes. Assemble the
tube sections by pushing one into the other until
the button snaps into place.
• Press the release button to separate the acces-
sories from each other.
1.3 Filling the boiler with water
• Remove the safety cap from the main unit.
• Using the funnel, pour a maximum of 2 litres of
tap water into the boiler. Hot water shortens the
heating-up time.
Note: With the unit standing on a level surface, the
boiler can be filled up to 2 cm below the top of the
filler neck.
• Do not use any detergents.
• Refit the safety cap onto the main unit, and ensure
that it is properly tightened.