I Ats (Automatic Transponder System); I Resetting The Transceiver - Icom IC-4088S Instruction Manual

I ATS
(Automatic Transponder System)
This allows the user to confirm whether or not a call has reached
the receiving party even if the operator is temporarily away from the
transceiver. No "Ring" tone is emitted with this function.
➥ While pushing [PTT], push
[MODE] to turn the function ON
and OFF.
• " " appears on the display.
• The transceiver starts to send a
searching signal every 60 sec.
- When the transceiver receives
an answer back signal, "
stays on the display until the
next search transmit.
- If no reply is received, "
NOTE: Above setting is for the calling station only. A called party
automatically sends an answer back signal without any preset-
tings. All IC-4088S's operating on the same operating channel
will answer back to the call in the surroundings communications
area.
' ' Resetting the transceiver
Initialize the operating conditions
before using the transceiver for the
first time, or if the function display
shows erroneous information.
➥ While pushing [Z] and [MODE],
push [PWR] for 1 sec. to initial-
ize the transceiver.
CAUTION: Resetting the trans-
ceiver returns all settings to
their defaults.
[PTT]
"
[MODE]
" blinks until the next search transmit.
[PWR]
[MODE]
[Z]
OTHER FUNCTIONS
10
10
21