Advertisement
F. Belt Adjusti ng
1. If the belt is too tight or too loose, loosen the nut A as shown in the diagram
first, then adjust the nut B, if the belt length is too long, adjust downward; if
the belt length is too short adjust upward. Adjust the belt to the proper
position then tighten the nut A.
2. The gap between nut A and B has to be within 35mm(1.4"). If the gap still
exceeds 35mm limit after first step, please loosen up the screws on C and
adjust the belt to the proper length. Tighten the screws and follow 1st step
again. (See Fig.8)
PDF created with pdfFactory trial version
www.pdffactory.com
Fig .8
Advertisement
