Setup; Charging - Panasonic SDR-SW20PC Operating Instructions Manual

Setup

Insert the battery into the unit and charge it.
Set the mode dial to [OFF].
1
The unit runs on AC power (status indicator lit red) and
the battery cannot be charged when the mode dial is set
to any position other than [OFF].
Open the card/battery
2
door.
Slide the lock to the OPEN side and
lift the projection with a finger to
open.
3
Insert the battery.
Ensure that battery is oriented
correctly, and push it into the
compartment in the direction of the
[ ] until it snaps into place and it is
locked by the lever.
(To remove the battery,
press the lever downward.)
Close the card/battery
4
door.
Press [ ] until hearing the door
snap closed.
Connect the AC adaptor
5
(supplied).
Connect the AC cable to the AC
adaptor and then to an AC outlet.
To AC outlet
Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use
the AC cables and AC adaptors of other devices with this unit.
22
VQT1M21
1

Charging

Lever
Check that the red marker of the lock is
no longer visible.
AC cable
Small gap here.
OPEN
Projection
Press here.
OPEN
AC adaptor